MAX1084AESA+【PDF 5/16 页】IC ADC 10BIT 400KSPS 8-SOIC

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录2007

1页 2页 3页 4页 [5页]6页 7页 8页 9页

MAX1084/MAX1085

400ksps/300ksps, Single-Supply, Low-Power,

Serial 10-Bit ADCs with Internal Reference

______________________________________________________________________________________

Figure 14 shows the recommended system ground con-

nections. Establish a single-point analog ground (“star”

ground point) at GND, separate from the logic ground.

Connect all other analog grounds and GND to this star

ground point for further noise reduction. No other digital

system ground should be connected to this single-point

analog ground. The ground return to the power supply for

this ground should be low impedance and as short as

possible for noise-free operation.

High-frequency noise in the VDD power supply may affect

the ADC’s high-speed comparator. Bypass this supply to

the single-point analog ground with 0.1F and 10F

bypass capacitors. Minimize capacitor lead lengths for

best supply-noise rejection. To reduce the effect of sup-

ply noise, a 10

resistor can be connected as a lowpass

filter to attenuate supply noise (Figure 14).

Definitions

Integral Nonlinearity

Integral nonlinearity (INL) is the deviation of the values

on an actual transfer function from a straight line. This

straight line can be either a best-straight-line fit or a line

drawn between the endpoints of the transfer function,

once offset and gain errors have been nullified. The

static linearity parameters for the MAX1084/MAX1085

are measured using the endpoints method.

Differential Nonlinearity

Differential nonlinearity (DNL) is the difference between

an actual step width and the ideal value of 1LSB. A

DNL error specification of 1LSB or less guarantees no

missing codes and a monotonic transfer function.

Aperture Jitter

Aperture jitter (tAJ) is the sample-to-sample variation in

the time between the samples.

Aperture Delay

Aperture delay (tAD) is the time defined between the

falling edge of CS and the instant when an actual sam-

ple is taken.

Signal-to-Noise Ratio

For a waveform perfectly reconstructed from digital

samples, signal-to-noise ratio (SNR) is the ratio of full-

scale analog input (RMS value) to the RMS quantization

error (residual error). The theoretical minimum analog-

to-digital noise is caused by quantization error and

results directly from the ADC’s resolution, (N bits):

SCLK

DOUT

FIRST BYTE READ

SECOND BYTE READ

HIGH-Z

SCLK

DOUT

HIGH-Z

Figure 12. SPI/MICROWIRE Serial Interface Timing (CPOL = CPHA = 0)

Figure 13. QSPI Serial Interface Timing (CPOL = 0, CPHA = 1)

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式